Lebanon heating help, extremely fast
We repair and replace gas, electric and oil furnaces, and heat pumps in Lebanon, Ohio. Any brand, any age, diagnosed and quoted before we start. Most calls get handled the same day, and someone answers the emergency line at any hour.
Furnace repair, replacement, and heat pumps from techs who've worked every kind of Cincinnati-area home — with a 24/7 line for the January no-heat call.
Every way a Lebanon home stays warm.
One room never gets warm. Is the furnace the problem?
Usually not. A furnace that satisfies the thermostat is doing what it was asked, and the room that stays cold is almost always a duct problem: a run that is too long or too small, a damper closed years ago and forgotten, a crushed flex duct in a joist bay, or a return that cannot pull enough air back for the supply to push. Adding return capacity fixes more of these houses than replacing the furnace does, and it costs a fraction of what a new system does. Ask for the airflow to be measured before anyone quotes you equipment.
What actually happens during a furnace tune-up?
It should be a list of measurements, not a look. Combustion analysis at the flue, gas pressure at the manifold, temperature rise across the heat exchanger, amp draw on the blower and the inducer, flame sensor cleaned and its microamp signal read, safeties tested rather than assumed, and a look at the heat exchanger itself. Ask for the numbers afterwards. A visit that produces no readings gives you nothing to compare against next year, and year-on-year comparison is most of what a tune-up is actually for.
The heat is out and it is the middle of the night. What now?
Check three things before you call, because one of them fixes it more often than people expect. The furnace switch, which looks like a light switch on or near the unit and gets knocked off. The breaker. And the filter, if it has been in longer than you can remember. If none of those does it, call. The line is answered at any hour, and a house losing heat in an Ohio January is not a call worth putting off until morning, both for the house and for the pipes in it.
Why does my furnace turn on and off every few minutes?
Short cycling. The furnace reaches its limit, shuts down, cools, and starts again, which burns more gas than running a full cycle would and wears the ignition components out early. The usual causes are a clogged filter starving the return, a flame sensor that needs cleaning, an oversized furnace that heats the thermostat faster than it heats the house, or a flue problem tripping the safety. The first is free to rule out yourself. If a new filter does not settle it within a day, the rest want a technician, because two of them are safety devices doing their job.